ASSEMBLING THE BABY PLATEN INSERT
Below are the instructions for assembling the Baby Platen Insert for use with the T-Lock Platen on the Brother DTG Printers.
1. Locate the Baby Platen Insert, two T-Lock Brackets and four (4) screws.
2. Place the T-Lock Bracket under the Baby Platen Insert and put two screws through the top of the insert so the head of the screw goes into the counter sunk hole. Use a screw driver (not included) to tighten the screw. Do not over tighten.
3. Repeat the process for the 2nd T-Lock Bracket.
WORKING WITH THE BABY PLATEN INSERT
To install the Baby Insert, you will want to place the two T-Lock Brackets on the bottom side of the Baby Insert into the two slots on the T-Lock Base. The two Registration Bolts will slide into the two corresponding holes in the Baby Insert.
Then rotate the center pieces of the T-Lock Brackets to lock the Baby Insert into place.
ARTWORK POSITIONING
When preparing the artwork for printing, use a 7” x 8” artwork template and the Baby Platen option in the appropriate Brother GT Driver.