Extra Long Sleeve Insert

Maximize the power of your Brother® DTG printer by expanding the products that you can print on. The T-Lock Extra Long Sleeve Insert allows for the printing on two (2) long sleeves at the same exact time. Increase your production speed of a desirable print location to increase your  potential profits.

NOTE: The T-Lock Platen Kit already comes with one Long Sleeve Insert.  A 2nd Long Sleeve Insert is available for purchase.

The easy-to-use T-Lock platen system allows Brother® DTG users the ability to print two Long Sleeves at the same time. This platen insert works on all the Brother DTG printers (GT-541, GT-782 and GT-3 series).

ASSEMBLING THE LONG SLEEVE PLATEN INSERT

Below are the instructions for assembling the H-Base Platen Insert for use with the Long Sleeve Insert on T-Lock Platen on the Brother DTG Printers.

1. Locate the H-Base Platen Insert, two T-Lock Brackets and four (4) screws.

Affixing T-Lock Brackets to H-Base Insert

Screwing T-Lock Brackets to H-Base Insert2. Place the T-Lock Bracket under the H-Base Platen Insert and put two screws through the top of the insert so the head of the screw goes into the counter sunk hole.  Use a screw driver (not included) to tighten the screw.  Do not over tighten.

3. Repeat the process for the 2nd T-Lock Bracket.

NOTE:  The H-Base Insert allows for two Long Sleeve Inserts to be used at the same time.  The Extra Long Sleeve Insert can be purchased by clicking here.

WORKING WITH THE LONG SLEEVE PLATEN INSERT

To install the Long Sleeve Insert, you will want to place the two T-Lock Brackets on the bottom side of the H-Base Insert into the two slots on the T-Lock Base.  The two Registration Bolts will slide into the two corresponding holes in the H-Base Insert.

Installing H-Base Insert on T-Lock Base
Then rotate the center pieces of the T-Lock Brackets to lock the H-Base Insert into place.

Rotating the Center Piece of T-Lock Bracket

Then drop the Long Sleeve Insert into the desired location on the H-Base Insert.

Installing Long Sleeve Insert on T-Lock Platen

Use the included wing nuts to secure the Long Sleeve Insert to the H-Base Insert.

Securing Long Sleeve Insert on T-Lock Platen

LONG SLEEVE INSERT ARTWORK POSITIONING

When printing on the Cap Platen Insert, it is recommended to use the artwork template. To download the artwork templates, click here.